Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterGarage Door Before & After in Tempe, AZ
We could tell you we do clean work. Every garage door company says that. But a torn panel, a mangled track, or a spring that let go at 6 a.m. tells a better story when you can see what we walked into and what we left behind. These are real jobs from Tempe, Chandler, and Mesa, documented with the same photo record every Servo customer receives. The camera doesn’t upsell.
Recent Transformations
Torsion Spring Failure in South Tempe
Homeowner off Rural Road called at 7:20 a.m. because the door wouldn’t lift more than six inches. We found a torsion spring with a clean break at the coil, which had thrown the door’s weight onto the opener. The opener motor was straining hard enough to burn out. We replaced both springs as a set, reset the cable tension, and reran the opener travel limits. From arrival to a fully balanced door: 90 minutes.
Opener Logic Board Replacement in Tempe Gardens
Customer near Tempe Gardens hit the wall button and got nothing but a flashing light. Multi-meter showed the wall circuit had power but the logic board wasn’t sending voltage to the motor. On a 2018 LiftMaster, that board is replaceable for a fraction of a new opener. We swapped the board, reprogrammed the home’s two remotes and keypad on-site, and ran the full open-close cycle five times before leaving. The photo record shows the dead board next to the new one.
Door Replacement on a 1994 Clopay in North Tempe
A rental property near Tempe Town Lake failed its pre-lease inspection. The bottom panel was dented from what looked like a trailer hitch encounter, and the left rail had flared enough that the wheel was grinding. On a door that age, patching panels costs more than it’s worth. We recommended a full replacement with a 2-inch insulated Clopay. New track, new hardware, new seals. We left the old door dismantled and stacked by the dumpster, and the property manager had the written warranty in hand before we pulled out of the driveway.
Garage Door Off Track After Storm
A monsoon gust one August night knocked a door near Tempe Marketplace partway out of its rail. The right-side lower roller had jumped, and the panel was torqued at a nasty angle. We got the door back in the rail, replaced the roller and the three worst nylon wheels, and re-lubricated the track. Total repair: about an hour. Before work started, we showed the customer the bent roller and gave them the flat written price. They approved it right there in the garage.
Complete System Overhaul in Dobson Ranch
We rarely recommend a full overhaul. But a home in Dobson Ranch had a Wayne Dalton door, a Genie opener, builder-grade rollers, and springs that had been swapped once by a handyman. Nothing matched, and the door sounded like a garbage disposal. We replaced the springs, both cables, all rollers, the hinges, and the opener as one job. Written scope listed every part by name and price. The afternoon after, the customer could open her garage from the street and hear nothing at all.
Want Results Like These?
Every job above started with a phone call and a written price before the work began. No estimate surprises, no handshake promises. If your garage door is doing something it shouldn’t, call Servo Garage Doors Tempe at (602) 962-8352. We’ll show you what we found, what it costs, and we’ll photograph the after so you can see it yourself.
Written by Marcus Deller, Owner at Servo Garage Doors Tempe, serving Tempe since 2015.